A great rc cars skill source

When creating a knack source for rc cars, it isimperative to check that the components are adapted to the plate, for otherwisemake corrections (in terms of include holes where the feet). The printi...

When creating a capacity source for rc cars, it isimperative to check that the components are adapted to the plate, for otherwisemake corrections (in terms of tally holes where the feet). The printing platecan vary in size; my board has a size of 11x6 inches, quite standard to thedimensions of the components, to acclimatize to this size.

The steps are unconditionally easy:

-Tobegin, you must savor the plate drawing board track view on the innate boardcopper side, a simple decal is authenticated and each of the holes where the legs go,then gone a punch mark on these holes.

-Beforewe can continue to drill the plate and next check every the tracks past specificlabel sales at electronics stores or clearly when a remaining marker, thusprotecting the critical from the ski areas.

-Onceyou have marked and labeled plate had to put it in acid, using either theproducts found in electronics stores or does a combination of strong water, sold indrugstores and hydrogen peroxide, the latter requiring much longer if for thedissolution of copper excess.

-Afterthe dish we list, we cut off the remnants of alcohol ink pen and take effect toplace the components on the opposite side of the copper traces and solder thelegs on the copper traces.

Then we put the board along the rc cars transformer ina box. This is recommended by the stores selling electronics and further itemsavailable.

Recommendations

The rc cars regulator LM 338K (metal oval) is placedon the outside, bordering to the radiator, and in no stroke be placed on-board andwithout cooling radiator. The form is elongated by three wires soldered to theboard at the points marked E, R and S until. This is just amazing!

The LED is next placed on the outside holder mountedon the LED but this period in front of the bin and as previously we extend two wiresfrom the rc cars plate to the east.This can be preferably red or yellow and stays on during operation of thesource. K is the cathode (-) and are identified by their leg is shorter, A isthe anode (+) and identifies bearing in mind his foot longer. The T1 is preferably placeda little radiator fins on the base dish itself identifying the saver andemitter B1, C1 and E1.

---

Bagikan Artikel ini